Let's get to the point. Today, we will make the remote control. We were already finish with the plane, so we gonna put the motor to the plane. We will use the already-made remote control. I don't know about other places, but here in Thailand its price is about 900 baht($27). Actually, we can make it by ourselves for about 500 baht($15), but it takes time and skill.
Prepare the remote control ... you can buy it from anywhere.
Equipment are remote, controlling circuit, 2 motors, battery, 2 fans, and mast.
Connect the circuit to the 2 motors.
By connect the red wire to the side that have a red dot and the other to the other side.
Put the fans on the motors
It should look like this.
Measure the wings each side from the center about 11-13 cm to place the motors.
Glue it.
Put the motor at the place we glue and wait for it to dry.
(Make sure that they aren't crooked.)
Place to tape on it to make sure that it is strong enough.
It should look like this.
Repeat it to the other side.
Keep the wire needly.
Put the wings with the motor to its body.
Finish for today!!!
However, the plane is not going to take off yet. Next time we will need to find its center because without it, your plane will bent over left and right.
See you next time
No comments:
Post a Comment